Then just program with the nRF Connect v2.6.0 Programmer Application, as you have already done. Set RAM_START=0x20000008, as the first 8 bytes are used by the MBR for interrupt forwarding and adjust the size accordingly by setting RAM_SIZE=0x3FFF8. You should also set and FLASH_SIZE=0xDF000 to make sure that there is room for the bootloader at the end of the flash. Set FLASH_START=0x1000 to place the application right above the MBR. Step 1: Update the Preprocessor Definitions by removing BOARD_PCA10056 and inserting BOARD_PCA10059: You already have found the peripheral blinky example, so you could take the central blinky example (examples\ble_central\ble_app_blinky_c) and do the following modification: What you need to do is use a peripheral and a central. In no event shall Rowley Associates, SEGGER Microcontoller, its employees, its contractors, or the authors of this document be liable for special, direct, indirect, or consequential damage, losses, costs, charges, claims, demands, claim for lost profits, fees, or expenses of any nature or kind. ![]() I'm not quite sure that this is what you are looking for? You can read more about the serialized application example here. The other board serves as connectivity board and supplies the radio connection. The ble_connectivity example is an example you can use to run a serialized application.īy serialized application you have two boards connected by wire, where one board serves as application board and hosts the actual Bluetooth or ANT application. NRF5_SDK_15.2.0_9412b96/components/serialization/common/struct_ser/ble/ble_gap_struct_serialization.hīecause as you see by the error message, Segger Embedded Studio can't find them. There's a blog post (posts?) by Nordic on setting up Eclipse - and some forum posts from users.NRF5_SDK_15.2.0_9412b96/components/libraries/bootloader/dfu/nrf_dfu_trigger_usb.c If you're familiar with Keil, you could also look at those projects for clues. is the latest entry level debug probe (emulators) for TI embedded processors. (SES obfuscates this a bit with its "placement" XML files - instead of using the GCC linker script directly). Other debug probes that only support JTAG, like the IAR I-Jet and Segger. There may also be some reliance on specific Section names. I think the main hurdle would be getting the Linker Script right - as you have to cope with the memory (flash
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |